Page Comparison

The variable value can be True or False

Default setting = True (recommended)

True = Driver pack will be downloaded from CapaOne, if it doesn't exist on the FrontEnd server

False = Driver pack will not be downloaded from CapaOne, if it doesn't exist on the Frontend server

The variable value can be True or False

Default setting = True (recommended)

True = Allow installation of Windows 10 driver packs on Windows 11

False = Do not allow installation of Windows 10 driver packs on Windows 11

💡 Hardware vendors usually only provides Windows 11 driver packs for their latest hardware. Hence, if you set the value to False and your hardware is recently purchased, you will probably get a lot of no driver pack errors

The variable value can be True or False

Default setting = True

True = Packages will return status Failed in the CapaInstaller console, when a driver pack isn't found

False = Packages will return status Installed in the CapaInstaller console, when a driver pack isn’t found

The variable value can be True or False

Default setting = True (recommended)

True = Logged on end-user will be prompted to start the driver update

False = Logged on end-user will not be prompted to start the driver update

The variable only exists in the Publish and Push Driver Update packages

⚠️ It is not recommended to change the value !

The variable value can be True or False

Default setting = False(recommended)

True = Even if the newest driver pack is already installed, it will be reapplied

False = If the newest driver pack is already installed, it will not be reapplied

The variable value can be True or False

Default setting = True

True = The common drivers from the OSD share will not be downloaded and installed, when a driver pack is found

False = The common drivers from the OSD share will be downloaded and installed, even when a driver pack is found

The variable only exists in the PreDriverCopyScript

The variable value can be a full or a partial IPv4 address on endpoints that should be excluded

Default setting = ""

The * character must be used as a wildcard, when defining partial IPv4 addresses

The , character must be used when defining multiple IPv4 addresses

Example : 192.168.100.*,192.168.101.*

The variable value can be a full or a partial IPv4 address on gateways that should be excluded

Default setting = ""

The * character must be used as a wildcard, when defining partial IPv4 addresses

The , character must be used when defining multiple IPv4 addresses

Example : 192.168.100.*,192.168.101.*

The variable value can be the NetBIOS name of endpoints that should be excluded

Default setting = ""

The , character must be used when defining multiple endpoints

The variable value can be the name of the hardware models that should be excluded

Default setting = ""

The hardware model name is matched with the “System Model” value from the “SysInfo” command

The , character must be used when defining multiple endpoints

The variable value can be True or False

Default setting = True

True = External power connection is required

False = External power connection is not required

This setting only affects laptops

The variable value can be True or False

Default setting = False

True = Custom inventory is not collected during package exection (not recommended)

False = Custom inventory is collected during package execution