The PerformanceGuard agent will open and send aggregated performance data to PerformanceGuard through a normal TCP/IP connection at every delivery interval. The delivery interval is 180 seconds (that is three minutes) by default, but can be adjusted to any value in the range 1-30 minutes. To adjust the delivery interval in the PerformanceGuard web interface, select ADMINISTRATION > Setup > Parameters > Status and change the DELIVERY_INTERVAL setting. You can only do this if you're a PerformanceGuard administrator.

On average, 3,6 KB of data is transferred from a single agent on an end user computer to PerformanceGuard at every delivery. That's the equivalent of 20 bytes per second. The amounts may of course vary depending on user behavior and your configuration, but our customers generally find that PerformanceGuard traffic is completely negligible compared to other traffic.

For end-user computers the PerformanceGuard agent will use much less than 1% on average of the total available CPU. For PerformanceGuard agents running on Citrix servers a higher CPU consumption of nearly 1% can occur, especially if a lot of transaction filters are enabled, and the server has a lot of HTTP traffic to the servers in the filter.

On average, 400 bytes are transferred from a single session on a Citrix server to PerformanceGuard at every delivery. With 50 concurrent sessions on a Citrix server, approximately 110 bytes/sec (total) are transferred from the agent to server. This may vary depending on user behavior and your configuration.

Because the computer doesn't need to be restarted when you install the agent, it can take a while before you get startup data from the agent. You can of course restart the computer in order to speed up the process, but for technical reasons you should wait at least ten minutes after installing the agent before you restart the computer.

Nowadays the agent icon is by default not shown. For more information, see the troubleshooting section on Agent Icon Is Missing.

See the troubleshooting section in Agent Can't Connect.

The agent retries for every delivery interval (by default every 180 seconds). For every five retries, it clears its collected data to avoid accumulating too much data that could eventually lead to memory problems.

Use the Computer Overview and remember to click the overview's Export button to view exactly which computers run which agent versions.

Use a Berkeley Packet Filter. See Agent Configuration > Network Report in Agent Configuration Group Settings. You can only do this if you're a PerformanceGuard administrator.

Yes, but if you run the agent and WinPCap on a 64-bit computer, you should read Agents and Wireshark/WinPCap.

This can happen in mixed 32-/64-bit environments, for example if the PerformanceGuard agent that should read 32-bit dll-based performance counters is a 64-bit agent. To solve this problem, do the following on the computer that runs the agent: Select

Image Added /Start, type services.msc and press ENTER. Then right-click the service Performance Counter DLL Host, select Properties, set Startup type to Automatic, start the service, and click OK. This will make 32-bit counters available in 64-bit applications. Finally, restart the PerformanceGuard Agent service.