Agent Command Line Options
Martin Moghadam
Youssef Benarab
The following command line parameters are available for the agent executable. Unless otherwise indicated, only a single option should be supplied.
Option | Alias | Usage |
|---|---|---|
-install | -i | This option is used to install the PerformanceGuard agent as a service on the computer |
-deinstall | -d │ -u | This option is used to remove the service from the computer. If the service hasn't been installed, it has no effect. |
-run | -r | Use this option to run the agent directly from the command line. |
-Restart |
| Use this option to restart (or start) the service. |
-StopService |
| Use this option to stop the service. |
-InstallGUI | -ig | Install the PerformanceGuard agent GUI interface. |
-UnInstallGUI | -ug | Remove the PerformanceGuard agent GUI interface from startup. |
Special Values | ||
-RegBase=<key name> |
| Specifies an alternative base key for the agent to use. Default is "E2EAgent". |
-Help |
| Prints command line help. |
-ConfigFile=<file name> |
| Read values from a configuration file in addition to reading the registry. The configuration file must be in ANSI format. |
-WriteConfigFile=<file name> |
| Write configuration values to a named file, for example to copy values from the registry. The configuration file must be in ANSI format. |
-IgnoreRegistry |
| Don't read configuration values from the registry. |
-UpdateRegistry |
| Update the configuration values in the registry, for example to update registry from a configuration file. The configuration file must be in ANSI format. |
Search this documentation
On this page
In this section