CapaBitLocker v4.0 - Variables

CapaBitLocker v4.0 - Variables

BitLocker variables

The variable value can be All or System Default setting = All (recommended) All = All fixed drives are encrypted/decrypted System = Only the operating system drive is encrypted/decrypted Disk Management System All
The variable value can be True or False Default setting = False (recommended) True = Package Status will be set to Failed in the CapaInstaller Console, when the first non-critical error is detected False = Package status will be set to Installed in the CapaInstaller Console, when non-critical errors are detected In the example below, an error is written to the logfile, because gbFailPackageOnError is set to True True CapaInstaller Console View In the example below, a warning is written to the logfile, because gbFailPackageOnError is set to False False CapaInstaller Console View
The variable value can be True or False Default setting = True (recommended) True = The last 4 digits of the Recovery Key ID and the Recovery Key Password is replaced with asterisk characters in the log file located on the endpoint False = The full value of the Recovery Key ID and the Recovery Key Password is visible in the log file located on the endpoint True
The variable value can be True or False Default setting = True (recommended) True = Recovery Key is saved in Active Directory False = Recovery Key is not saved in Active Directory True :light_bulb_on: CapaBitLocker automatically detects if the domain is availabe before saving the recovery key in Active Directory
The variable value can be True or False Default setting = True (recommended) True = Recovery Key is saved in CapaInstaller Custom Inventory False = Recovery Key is not saved in CapaInstaller Custom Inventory True
The variable value can be True or False Default setting = True True = Package will wait for encryption of drives to finish, before changing status to Installed False = Package will initiate encryption of drives and change status to Installed afterwards :light_bulb_on: All recovery keys are saved and auto-unlock on data drives are enabled, immediately after drive encryption has been initiated
The variable value can be a number between 0 and 10 Default setting = 1 0 = BitLocker is suspended infinitely and must be resumed manually 1-10 = BitLocker is suspended until the specified number of reboots has been performed :light_bulb_on: BitLocker is suspended instantly

Common variables

The variable value can be a full or a partial IPv4 address on endpoints that should be excluded Default setting = "" The * character must be used as a wildcard, when defining partial IPv4 addresses The , character must be used when defining multiple IPv4 addresses Example : 192.168.100.*,192.168.101.*
The variable value can be a full or a partial IPv4 address on gateways that should be excluded Default setting = "" The * character must be used as a wildcard, when defining partial IPv4 addresses The , character must be used when defining multiple IPv4 addresses Example : 192.168.100.*,192.168.101.*
The variable value can be the NetBIOS name of endpoints that should be excluded Default setting = "" The , character must be used when defining multiple endpoints
The variable value can be the name of the hardware models that should be excluded Default setting = "" The hardware model name is matched with the “System Model” value from the “SysInfo” command The , character must be used when defining multiple endpoints
The variable value can be True or False Default setting = True True = External power connection is required False = External power connection is not required :light_bulb_on: This setting only affects laptops
The variable value can be True or False Default setting = False True = Custom inventory is not collected during package exection (not recommended) False = Custom inventory is collected during package execution